|
12-28-2013, 07:54 PM | #13 | ||||||
|
Charlie reason I left Red Dot off the cheat sheet is it's same position as TiteWad on the quickness chart. I can't find any low pressure 20 gauge recommended loads for TiteWad, which I have plenty of. Emailed Hodgen looking for Titewad loads no response. Never loaded the 20 but hear it needs slower powder than 12 gauge low preassure shells. If I am thinking about it wrong let me know.
Bill |
||||||
12-29-2013, 09:16 AM | #14 | ||||||
|
Bill, here is a load I am using: 20ga., 7/8oz, Winchester AA hulls, CCI 209 primers, 14.5 grains of Green Dot, Winchester Wads #WAA20 or Claybuster CB 1078-20.
Velocity= 1150 fps Pressure= 8960 psi |
||||||
12-30-2013, 08:56 PM | #15 | ||||||
|
Thanks Buddy.
Have some Claybuster 1075-20's on the way 3/4 oz charge bar too. Enough Unique on hand to get started. Word is Greentop has a good shotgun powder supply. Bill |
||||||
01-09-2014, 06:50 AM | #16 | ||||||
|
Internet search of vendors no powder. Half dozen local and near local gun shops same thing, walked into a place I did not expect and found a shelf full of International Clays. Ready to load 3/4 oz 20's now.
Bill |
||||||
01-10-2014, 12:44 PM | #17 | ||||||
|
I can also recommend 20/28 powder in a 3/4 oz 20 gauge load.
|
||||||
|
|