|
 |
 |
|||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||
 |
 |
12-01-2013, 09:00 PM
|
#3 | ||||||
|
They have been advertising new non-tox shot. Not sure if it is steel or bismuth though.
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
12-01-2013, 09:15 PM
|
#4 | ||||||
|
According to the web site rioammo(dot)com they are producing both steel and bismuth loads in 12 gauge and 20 gauge.
__________________
"You can observe a lot by just watching" - Yogi Berra |
||||||
|
|
|
||||||
|
|
|
|
|
|
12-03-2013, 02:00 PM
|
#5 | ||||||
|
The new shot you're thinking of is the Fiocchi Tundra. I've heard absolutely nothing about it, it came out a couple years ago. It's expensive, only slightly cheaper than Kent, at least the last time I checked.
DLH
__________________
I was as virtuously given as a gentleman need to be; virtuous enough; swore little; diced not above seven times a week; went to a bawdy-house once in a quarter--of an hour; paid money that I borrowed, three of four times; lived well and in good compass: and now I live out of all order, out of all compass. Falstaff - Henry IV |
||||||
|
|
|
||||||
|
|
|
|
|
|
12-12-2013, 02:54 PM
|
#6 | ||||||
|
I'm new at this so forgive me if my protocol is not quite right, but I am trying to find out if shooting 3", 1 1/4oz Bismuth in my 12ga will be OK. I have always shot 2 3/4", 1 1/4 oz, 3 1/4 dram bismuth but it's hard to find (not at Cabelas any more). My gun is frame size "2" (although it looks like some exponent-like marking to the right of the "2"), so it seems like a big-framed 12ga. Barrels are marked "Titanic Steel" so it's a grade DH by the website chart. Wt. of barrels is 4 with an "exponent" of 5. Looks to be in great condition. Expect to shoot maybe 200 rounds a year. If anybody can help me out, would sure appreciate it.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
12-12-2013, 03:12 PM
|
#7 | ||||||
|
Peter: The simple answer is NO in my opinion your gun is safe for 2 3/4" shells of reasonable pressure not 3"!! Rio now loads Bismuth in 2 3/4". Check out the link below. Better yet learn to handload low pressure bismuth loads or check out RST offering of niceshot.
http://www.ableammo.com/catalog/hunt...679_16742.html |
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Craig Larter For Your Post: |
|
|
|
12-12-2013, 03:16 PM
|
#8 | ||||||
|
Thank you VERY much (could have saved my gun). I'll check out the site you suggested and perhaps I'll try the loading too.
Peter |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Peter Fink For Your Post: |
 |
|
|
Linear Mode
