|
01-08-2021, 12:59 PM | #3 | ||||||
|
Peter passed away last year, but his son is now working full time in the shop. Of course, Wendy is always there.
|
||||||
01-08-2021, 02:35 PM | #4 | ||||||
|
Was going to call today, but was already after 5:00. Have exchanged emails with Wendy.
__________________
"How kind it is that most of us will never know when we have fired our last shot"--Nash Buckingham |
||||||
The Following User Says Thank You to Harold Lee Pickens For Your Post: |
hammers |
01-08-2021, 03:37 PM | #5 | ||||||
|
hammers
i may have a pair of hammers that might be suitable if i had the throw in inches
|
||||||
01-08-2021, 04:31 PM | #6 | ||||||
|
Thanks for checking Walt.
35 mm is 1 7/16 inches. Measured like this:
__________________
"How kind it is that most of us will never know when we have fired our last shot"--Nash Buckingham |
||||||
01-08-2021, 07:44 PM | #7 | ||||||
|
Make sure you get the screw from Dyson because the Brits use Britsh Association threads on there guns and you may be hard pressed to find them here. MSC has the taps and dies but you may exceed your credit card limit
|
||||||
The Following User Says Thank You to Craig Budgeon For Your Post: |
01-08-2021, 07:53 PM | #8 | ||||||
|
|
||||||
hammers |
01-09-2021, 06:31 AM | #9 | ||||||
|
hammers
these measure 1.5 inches but if you have access to a welder they might work ok
|
||||||
01-09-2021, 07:25 AM | #10 | ||||||
|
Dan Morgan in VT may have some. He goes back and forth to the UK, Scotland, several times a year, at least he did before covid. Hosford welded a tip for me on a hammer and Dan cut the checkering. Good luck..
|
||||||
|
|