I see 10 ga Cheddites are out of stock again.

[Milton C Starr]

Originally Posted by Paul Harm

Maybe a drill [ press ] with a key chuck would solve your spinning problem. The difference in .160 and .250 is .090. If half of that is folded over your crimp depth will change .045. Half way between a 1/16 and a 1/32 of an inch. That isn't a whole lot.

In my opinion being on the shorter side is better than trying to roll crimp 1/2" of hull like I have read some people do. I dont think roll crimps are that finicky I will set the drill press up tomorrow I just got to find somewhere to put it haha. I think the problem is the 10 ga crimper is about 3/8s on the shaft and the drill is 3/8s so theres no room for it to actually grab it. I didnt realize this until now and I checked them with a mic. I should have bought a 10 gauge hull vice I have one for the 8 gauge. I can easily hold the 8 ga hulls by hand though while roll crimping them only takes 2-3 seconds. Heres the 8 gauge jaws, looks identical to the ones PR sells but I dont see a 8 gauge one on their website I dont have a base for it.