|
 |
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Visit Mike Koneski's homepage! | | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
03-17-2021, 12:27 PM
|
#3 | ||||||
|
They are out now.
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
03-17-2021, 01:19 PM
|
#4 | ||||||
|
Total newbie stupid question: Are 209 primers interchangeable (other than Cheddites which I know are sized different....). I know some manuals say "DO NOT INTERCHANGE PRIMERS OR YOUR HOO HOO WILL FALL OFF...." But if I'm shooting lead bullets in my 9mm they don't care if they're CCI, Winch or Federal, they go bang and shoot the same. I have 5,000 Cheddites and now 5,000 Rio's on the way (no shot or powder, but hey!!!)
__________________
Nothing ruins your Friday like finding out it's only Tuesday |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-17-2021, 02:45 PM
|
#5 | |||||||
|
Quote:
You can go to my local trap club any Tuesday and sit at the round table of knowledge and I can promise you there will be at least a dozen rocket scientist that will tell you any primer will work in any load. My approach is if it is not in the loading manual or has not been tested I am not touching it. I think it was one of Rosters studies that showed an increase of almost 2,000 psi could be achieved by a simple primer interchange. I think it was Roster, others will correct me if I am in error on that. If your question of interchanging primers was geared more towards size then see the attached chart. Looks to me like once you use a RIO you have eliminated several of the others based upon the diameters. |
|||||||
|
|
|
|||||||
|
|
|
|
|
|
03-17-2021, 02:49 PM
|
#6 | ||||||
|
Some primers burn hotter than others, so I would say the brand of primer can have a big impact on the recipe.
__________________
"Life is short and you're dead an awful long time." Destry L. Hoffard "Oh Christ, just shoot the damn thing." Destry L. Hoffard |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-17-2021, 02:57 PM
|
#7 | ||||||
|
Tom Roster has tested various primers side by side. Not much difference in velocity, slightly more in pressures.
http://www.armbrust.acf2.org/primersubs.htm
__________________
"Striving to become the man my dog thinks I am" |
||||||
|
|
|
||||||
|
|
|
| The Following 3 Users Say Thank You to John Dallas For Your Post: |
|
|
|
03-17-2021, 03:17 PM
|
#8 | ||||||
|
I use Winchester, CCI, Nobel and Fiocchi primers. Cheddite hulls I use Nobel and Fiocchi. Domestic hulls I use Winchester and CCI. I go by primer pocket size only.
BTW, they are out of Rio primers now because Andy had to post that they had 209 primers. Way to go Andy!! 
|
||||||
|
|
|
||||||
|
|
|
|
|
|
03-17-2021, 03:22 PM
|
#9 | ||||||
|
Thank you everyone for the tips. Mike, you're late to the soup kitchen you don't get the soupy. But then again, I've seen your reloading "room". I do not feel sorry for you : )
__________________
Nothing ruins your Friday like finding out it's only Tuesday |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Andrew Sacco For Your Post: |
|
|
|
03-17-2021, 07:27 PM
|
#10 | ||||||
|
Prior to the current primer shortage one of my shooting buds often commented that Rios are too much trouble to use. I called him earlier and asked why that is ..... in addition to being somewhat oversize and thus hard seating in once-fired American hulls, their leading edge isn't as radiused as other 209 primers and can cause jams (in the seating station) of progressive loaders like MEC 9000's.
Last edited by Frank Srebro; 03-18-2021 at 06:45 AM.. Reason: Slightly reworded for clarity |
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
