|
 |
 |
|||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||
 |
 |
09-09-2023, 08:16 AM
|
#3 | ||||||
|
My guess is that something is timing out on your end? It could be on whatever you are using for a computer/tablet/connection, or your browser settings, or your connection, or your ISP, or....???
As well, I checked your account and the logs on the servers - and there are no anomalies in either? Sorry I can't be more helpful - but you didn't post a whole lot of information? John D. |
||||||
|
|
||||||
 |
 |
 |
| The Following 2 Users Say Thank You to John Dunkle For Your Post: |
|
|
|
09-09-2023, 11:08 AM
|
#4 | ||||||
|
Jim:
I have been learning the hard way, that is, I keep forgetting and making the same mistake, that I should write what I want to post first in a separate document on my computer, and then copy it, paste it onto the PGCA Forum, and then post it. Otherwise, as I linger over what I want to say, I get "timed out". Not sure if this addresses your problem.
__________________
"First off I scoured the Internet and this seems to be the place to be!” — Chad Whittenburg, 5-12-19 |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Russell E. Cleary For Your Post: |
|
|
|
09-10-2023, 04:08 AM
|
#5 | ||||||
|
If you're writing a long post it's a good idea is to copy your words before hitting the post button. Then if you don't see your post because you've timed out just open the new post or thread box again and paste your message. No need to write it in a separate document unless you want to keep a separate copy. Once you get used to doing that on each post you'll never have to start over.
|
||||||
|
|
|
||||||
|
|
|
| The Following 4 Users Say Thank You to Bob Brown For Your Post: |
 |
|
|
Linear Mode
