Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I use the same method as big friend ten and adapted an RCBS press by removing the adaptor bushing and mounting the 8 ga case holder. I picked up a small bench top drill press to use for roll crimping the cases. This method works much faster and gives a more consistent result than the manual swage die I made. Good luck
The Following User Says Thank You to Allen Peterson For Your Post: