Hinge pin removal ? - Parker Gun Collectors Association Forums

		Parker Gun Collectors Association Forums Parker Forums Parker Restoration
Hinge pin removal ?

Notices

Welcome to the new PGCA Forum! As well, since it is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and
You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................

If you are registered to the forum and keep getting logged out: Please Click Here...

Welcome & enjoy!

Thread Tools

Display Modes

BIT SIZES FOR ROLL PIN SCREW HEADS

04-01-2014, 10:31 PM

#11

Member
J. A. EARLY PGCA Member

Member Info
Join Date: Nov 2010 Posts: 1,967 Thanks: 4,045 Thanked 2,713 Times in 878 Posts

BIT SIZES FOR ROLL PIN SCREW HEADS

Tom,

I found two bit sizes needed checking several screws. You can buy these individually from Brownells so you don't have to buy the entire set:

340-5 (.340 shank diameter- .040 blade thickness)

300-3 (.300 shank diameter - .030 blade thickness)

I would buy a couple of each if I was going to make a habit of this.

Previous
left arrow key Next
right arrow key Close Move

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 10:29 PM.