![]() |
![]() |
![]() |
|||||||||||||||||||||||||||||||||||||
|
![]() |
![]() |
![]() |
#3 | ||||||
|
![]()
thanks for the post i bet all the harder shot even to steel will be pretty close in pressures...gonna call up them folks and ask for some pressure info on their products.... charlie
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#4 | ||||||
|
![]()
Mark, I sent them a request. Paul
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following User Says Thank You to Paul Harm For Your Post: |
![]() |
![]() |
![]() |
#5 | ||||||
|
![]()
I am not sure what constitutes low pressure, but after having had the following loads tested, these were the average pressures and speed:
1 1/8 ITX Velocity PSI Grains (Longshot) 1323 10266 26 1273 9300 25 1245 8400 24 I personally opted for the 24 grains
__________________
Fox Island Chesapeake Kennels Home of AKC Dual Award Winner CH Anubis Treasured Bettis MH |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following User Says Thank You to Theodore LeDurt For Your Post: |
![]() |
![]() |
![]() |
#6 | ||||||
|
![]()
hi, were these loads for 10 or 12 ga? thanks scott
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#7 | ||||||
|
![]()
Theodore,
Would you share with us the hull, wad, and primer? Were your loads fold or roll crimp? Thanks! Mark |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#8 | ||||||
|
![]()
The ITX loads and pressures listed were for 12ga. The hulls were Federal 2 3/4", with paper base. The primers were Win. 209 and the wads were Gualandi (TUWGL12). The shot was number 4's.
__________________
Fox Island Chesapeake Kennels Home of AKC Dual Award Winner CH Anubis Treasured Bettis MH |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
The Following User Says Thank You to Theodore LeDurt For Your Post: |
![]() |
|
|