|
12-26-2013, 12:42 PM | #3 | ||||||
|
__________________
"You can observe a lot by just watching" - Yogi Berra |
||||||
The Following 5 Users Say Thank You to Russ Lindsay For Your Post: |
12-26-2013, 01:29 PM | #4 | ||||||
|
Thanks, Russ.
|
||||||
12-26-2013, 04:20 PM | #5 | ||||||
|
Does anyone know what the distance between the screw holes would be on these? Thanks.
|
||||||
12-26-2013, 05:33 PM | #7 | ||||||
|
Still pretty big for what I need. Its off a grade 3 1912 Ithaca Flues 16 gauge. It is one of the Krupp steel lightweights and the butt is only 4 3/8" by 1 3/8". I suppose I'll have to get this one and drill a new screw hole.
|
||||||
12-26-2013, 06:59 PM | #8 | ||||||
|
Bob, what is your existing hole spacing?
|
||||||
12-26-2013, 08:33 PM | #9 | ||||||
|
David, there is only about 2.2" between the existing holes. 3 3/8" would put them very close to the toe and heel.
|
||||||
12-27-2013, 08:37 AM | #10 | ||||||
|
I believe the London Guns pad has shorter spacing, maybe 3". Contact Mark Beasland for a measurement. I have a couple, but am not able to get to them. I believe the Repro No Shoc is 3 1/8 with small plugs, very useful for small guns.
|
||||||
The Following User Says Thank You to Bill Murphy For Your Post: |
|
|