Hi Jack:
I looked at the links for the super and thin sets. Of the ones you previously recommended, you would buy two of each of these bits for spares and to grind them for custom fits?
1. Butt Plate 360-4 or 360-5 (measured a variety)
2. Grip Cap 240-3
3. Trigger Guard 240-5
4. Front Tang 270-3
5. Rear Tang 210-5
6. Fore end iron 240-3 and 210-3 (front screw)
Thanks,
Mark
per previous post......
With proper driver tips, patience and perseverance and maybe some penetrating oil if needed, non gunsmiths can dismantle, clean and re-assemble their Parkers. You will also need a small hammer, drift punches (brass or nylon preferred over steel) and six inches of 1/4" dowel.
Here are two links. If you decide to DIY, don't scrimp on the driver sets. Your Parker will thank you in the field or at the range. No commission from Brownells but I'm happy with mine.
Jack
Magna tip super set
http://www.brownells.com/.aspx/pid=4...ER_SETS_trade_
Magna tip Thin Set
http://www.brownells.com/1/1/3693-ma...brownells.html[/QUOTE]