View Single Post
Unread 12-01-2019, 05:16 PM   #22
Member
Jimmerp
Forum Associate

Member Info
 
Join Date: Nov 2019
Posts: 44
Thanks: 70
Thanked 139 Times in 27 Posts

Default

Quote:
Originally Posted by edgarspencer View Post
James, The raised (eyebrow) edge of the fore end tip is not specific to certain grades, but to guns made prior to about 1923. While your fore end iron is serialized to the gun, removing the tip and latch will confirm they are, or are not correct, as they are both stamped with the SN of the gun they left the factory with.
Thank you sir,
I was a little excited about the possible wrong forend on the gun. This was a big leap into Parkers and I admit don't know enough about the finer details to be jumping in quite so boldly.
I did take a good fitting screwdriver, removed the screws and with a brass drift tapped out the latch and tip. They both carry the correct serial that match them to the gun. It has given me much relief.
So to close my part of this thread thank you all for the knowledge members have imparted. This is a lovely gun of which I am very proud to be the new caretaker.
Jim
James Purdy is offline   Reply With Quote
The Following User Says Thank You to James Purdy For Your Post: