View Single Post
Unread 09-03-2018, 11:03 PM   #6
Member
J. A. EARLY
PGCA Member
 
Jerry Harlow's Avatar

Member Info
 
Join Date: Nov 2010
Posts: 1,949
Thanks: 3,922
Thanked 2,665 Times in 867 Posts

Default

Boil, boil, boil with air blown in the voids between boils to get the oil out. You've got to get all the oil out somehow (was the gun ever hot blued to dissolve the solder that much?). Acetone and lacquer thinner soaks work also. Then you are ready to go.

I boil and if somehow oil still comes out I flood my boil tank so all the oil floats over the tank. That way I don't drag the barrels through oil on the way out.

If you get streaks in your bluing from oil which happens, you don't need to remove all of the good rust bluing that you have so far and start over. I learned this after screwing up every set I did due to oil, usually at the final time. Just take that oil streaked dark spot down until it is gone and keep bluing. It will catch up.

Just my 2 cents.
Jerry Harlow is offline   Reply With Quote