UPDATE: Ponsness/Warren 375 set up for 2 1/2" shells
I finally found some time to set up my PW for 2 1/2" shells. Things didn't work out as planned. I found out the regular length sizing die actually works better than the shorter one -- it supports the hull better and prevents the hull from collapsing. As far as the short wad guide stop goes, don't bother getting a new one. Just remove the existing one. The wad guide stops on its own when it comes into contact with the hull.
Bottom line: If you have a PW 375 set up for 2 3/4" shells and want to load 2 1/2" shells, the only thing you need to do is adjust the crimp dies and remove the wad guide stop.
Photos from top to bottom:
1) once fired 2 1/2" hull in short sizing die.
2) loaded 2 1/2" shell with crushed hull caused by crimping pressure on unsupported hull.
3) once fired 2 1/2" hull in regular (2 3/4") sizing die. (note additional support)
4) loaded 2 1/2" shell in regular 2 3/4" sizing die (ejects from sizing die perfectly fine).
5) finished 2 1/2" shells loaded without the use of additional "short parts."
__________________
We lose ourselves in the things we love; we find ourselves there too. -Fred Bear
|