View Single Post
Unread 03-28-2018, 05:23 PM   #15
Member
edgarspencer
PGCA Member
 
edgarspencer's Avatar

Member Info
 
Join Date: Sep 2011
Posts: 6,053
Thanks: 2,904
Thanked 11,371 Times in 3,072 Posts

Default

Robin, the method Brad used is the same as what is done in England. The bored out chamber is usually to the cartridge rim diameter. Rather than a square shoulder, the barrel tube has a very slight champher from the smaller diameter to the large diameter. This then gives a V groove weld prep.
edgarspencer is online now   Reply With Quote
The Following 2 Users Say Thank You to edgarspencer For Your Post: