Labor cost to fit barrels would depend on the rate of the shop doing the work and the amount of time it takes to fit up a given gun.
In most cases the .540 or .545 roll would tighten up most guns. The rolls can really be made in any diameter required. But those three above mentioned diameters are the ones that I have on order.
The rolls could be case hardened with the frame of it is being done, or they can be hardened separately. My intention was to harden them along with other frames that I may have to have done.
The purpose of this post is to just let people know what Breda is set up to make and what is in the works. If one has a need for the parts, so be it. If not, so be it.
__________________
B. Dudley
|