View Single Post
Unread 03-23-2019, 12:01 PM   #19
Member
Hixie
PGCA Member
 
Ted Hicks's Avatar

Member Info
 
Join Date: Feb 2016
Posts: 345
Thanks: 189
Thanked 818 Times in 198 Posts

Default

I think that XRF can be used to determine the elemental composition of steel and provide a fairly accurate "fingerprint" of the steel sample. It is a surface analyses technique and the sample tested needs to be big enough. These days they have hand-held analyzers that can provide almost "instant" results. Sulfur and phosphorous may not be detectable that way.

If only a small sample is available, it could be dissolved in a mineral acid and analyzed using ICP-AES which I think can detect and measure all of the elements Edgar listed. I am not a metallurgist but I would venture a guess that the elemental composition would be the same throughout the test sample except, perhaps, for the carbon content. Again I am guessing but I suspect that the carbon content may vary widely within the sample, i.e. higher at the surface compared to at the center of the test sample.
Ted Hicks is offline   Reply With Quote