The last bit of metal work that needed to be addressed on this A-1 Repro was, well... the Address.
What is the point in "Meridenizing" a Repro if it still has a Japanese makers mark on the barrel rib.
I sent the barrels to Glenn Fewless to have him laser weld up the whole makers mark. As well as 1" of the center matting so that the length of the legend could be made larger as to fit the new mark.
I then cleaned up the welds by hand.
I then had them rolled with the original Peerless Steel makers marks but Turnbull.
IMG_2843.jpeg
IMG_3172.jpeg
IMG_3173.jpeg
IMG_3174.jpeg
IMG_3175.jpeg
IMG_3422.jpg