Thread: brass hulls
View Single Post
Unread 06-02-2018, 08:39 PM   #3
Member
charlie cleveland
PGCA Member

Member Info
 
Join Date: Jul 2009
Posts: 12,986
Thanks: 0
Thanked 7,787 Times in 3,967 Posts

Default

harry i too use a hot glue gun on hunting loads..the 10 ga 1/8 inch card board wads are really tight in those hulls no trouble with shot falling out..i will try them on paper but it will really do good on the cans..this is a great and simple load if any one likes brass shells and by useing red dot powder no mess to clean up.... those hulls inside were a little dark after being loaded 3 times but still really clean....if i were shooting clays with these brass shells i would not have to glue the top wad in the wad really is tight....charlie
charlie cleveland is offline   Reply With Quote
The Following User Says Thank You to charlie cleveland For Your Post: