I made a simple jig with a lever that has a razor blade clamped to it. A dowel, turned to 12ga on one end, and 16 on the other (the only two gauges I trim to load 2 1/2") is adjusted so cut the correct length, as the shell bottoms out on the end of the dowel. I trim leftover 2 3/4" RST hulls and new paper hulls. Each hull requires about 5 seconds to trim to length. Cut is as clean as the uncut hulls from BPI.
With the leftover little rings you can make nice mobiles to stare at during dinner.
|