I had previously posted about the making of a horn grip cap for a Lefever Optimus 10g. that I am restocking. This post/tutorial is about making and fitting horn heel and toe plates for the same gun.
First the butt of the stock was roughed out to the desired length and an appropriate curve shaped into it. A horn buttplate blank was used for the heel and toe plates. A flat piece of horn could also have been used, but I had this blank laying around so it worked well for this. The owner of the gun provided me with another gun he owns that was fitted with heel and toe plates. From that gun I was able to get tracings of the plates to use as a guide template in making the new ones. The horn blank was cut up and each piece was shaped using a half-round file and finished with paper. The backs were then scraped out slightly as to reduce the surface area needing to be fitted to the wood. The back sides of the plates were also sanded to put a slight curve on them.
IMG_2397.jpeg
IMG_2398.jpeg
IMG_2399.jpeg
Then the heel and toe of the butt were cut off about 1/4" deep down to where the scallops start. The scallops are then marked out and rough cut in with a chisel. Then both surfaces are fine fitted to each plate using inletting black, chisels and scrapers.
IMG_2400.jpeg
IMG_2401.jpeg
IMG_2402.jpeg
IMG_2403.jpeg
IMG_2404.jpeg
IMG_2405.jpeg
Once both plates are fitted to the butt. They are both tacked in place with a few dots of super glue in order to preserve their fitment when finishing and installing the screws. The excess material is then taken down on the face and the sides. Then the face of the entire butt is given the appropriate contour. Finally the plates are drilled and countersunk for the installation of new screws.
IMG_2406.jpeg
IMG_2407.jpeg
IMG_2408.jpeg
IMG_2409.jpeg
IMG_2410.jpeg
The above represents about 5 hours of work.