Thanks Edgar, interesting. I know Craig Libhart does it the same way but these guys have years of experience.
I recently tried another way to get the pad fitted to the butt after getting it close to the final shape. Once it's close, I mounted the pad and used electrical tape on the wood. Hand sanding with a block is difficult and time consuming and trying to get the hard plate of the pad down to the wood without cutting through the tape and scratching the stock is difficult. What I did was loosen the screws of the pad enough that I could insert a spacer of maybe 1/4" and tighten the screws to the spacer. That left a gap where I could sand the hard pad of the stock at a slight angle with the sanding block. Just bevel a little at a time, take the block out and check the fit. Keep doing this until it matches. Worked like a charm!
|