Another note is that if you are making a new stock or refinishing an old stock where sanding of the butt is involved. it is a good method to grind the pad down close as i previously described and then do the final finishing of the pad when on the stock and also sanding the wood. Using a sanding block. This will provide an even surface from wood to pad.
This will also work best if using a pad that sands well by hand, such as the silvers and some of the other vintage pads.
A lot of modern pads do not finish too well by hand. Kick-eez pads finish great in the power grinding phase and finish ok by hand. Pachmyer pads are not all that great and limbsaver pads or horrible. Using oil for lubricant can help.
__________________
B. Dudley
|