View Single Post
Unread 10-13-2010, 03:58 PM   #6
Member
Side X Side
Forum Associate
 
richard lambert's Avatar

Member Info
 
Join Date: Aug 2010
Posts: 56
Thanks: 33
Thanked 34 Times in 8 Posts

Default

From 12006 "16 Ga. Gun Talk" Topic

ITHACA CHAMBERS -- The last Flues period catalogue (1925) states -- "Unless otherwise ordered Ithaca 28 Gauge and 20 Gauge guns are chambered for the standard 2 1/2 inch shell, 16 Gauge and 12 Gauge for the standard 2 3/4 inch shell and 10 Gauge for the standard 2 7/8 inch shell. Longer chambers are furnished if ordered on new guns without extra charge, but it should be remembered that shells of standard length do not give quite as good results in chambers which are longer than the shells and it should be remembered that extra long shells are more expensive and it is much harder to find a dealer who carries extra long shells in stock."

In the published book "The Parker Story, the Remington vintage specification sheets on pages 164 to 169 call for a chamber 1/8-inch shorter than the shell for which it is intended. I have a 1930-vintage VH-grade 0-frame 20-gauge and its chambers are 2 3/8 inches intended for the old 2 1/2 inch shells, eight years after the 20-gauge Super-X shell was introduced in a 2 3/4 inch case!!"

American Rifleman: "And here's the reason why better patterns resulted from slightly overlength shells in short chambers (or chambers marked 2 3/4" that weren't really that long): Remember that we're talking the pre-WWII days, paper cases and felt or cork wads, no plastic shotcups. One reason for pellet deformation back in those days is that the unprotected pellets would slam into the walls of the forcing cone when the gun was fired. However, if the paper case mouth opened into the forcing cone, the mouth of the shell itself afforded some protection to the shot charge, on its initial contact with the bore. Tests established that slightly shorter chambers resulted in tighter patterns. Some trap shooters even when so far as to shoot 3" shells in 2 3/4" guns. Today, of course, with plastic hulls and wads, there's no longer any pattern benefit to shooting longer shells in short chambers, because the wad itself does a much better job of protecting the shot."
__________________
richard lambert is offline   Reply With Quote
The Following 3 Users Say Thank You to richard lambert For Your Post: