You definitely need a scale. I have everything from 600s to 9000H. I also at one time owned a Lee. If I was just starting out again it would be the 600 over the Lee hands down. Some guys don't like them, but I would also but an adjustable charge bar for the 600. Then you can load any shell without worrying about different bars. Make sure it's for a singe stage press, not a progressive. When using my 600 I hand feed the primers. Sizemasters are nice, but the less costly 600 will do the same job, IMHO. If you go to the third page on this forum under "reloading tips" I posted a good thread that applies to all Mec single stage presses. Good luck.
__________________
Paul Harm
|