Mills, why go to the expense of chamber work and honing? The tubes will be what you are shooting out of.
|
I guess to make the tubes fit better
|
Quote:
Ken |
Talked to Briley this morning. To fit my 16 G hammer gun, they machine the tubes to fit the bore. Chambers have to be 2 & 3/4 inch, tubes index depth on the front of the chamber. Fitting 190 dollars over the cost of Tubes. This is not needed on a number of modern factory guns, others it is needed. Short or full length tubes same work required.
May get a 3rd opinion on my barrels . If posable watch the method used and examine through the bore scope myself. William |
Do what I would do and tell Briley to k/m/a and install the tubes in my barrels. $190 to bore out my chambers is ridiculous.
|
No way would I have anyone bore out my chambers. I’d keep the original barrels and find and fit another set that I have more faith in.
. |
Quote:
Quote:
Quote:
|
Quote:
|
And mine may be depending on which expert I listen to. Nice condition O Frame set of Hammer gun barrels rare bird.
William |
I took mine to the Southern and got opinions from several of the best experts. They all pronounced the patient dead though. That would be a good option for you. In your case, you have shot it without problems and may be you just need to keep to the lowest pressure.
|
All times are GMT -4. The time now is 01:19 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org