Damascus Restoration HEEEEELP
3 Attachment(s)
Everyone here has been very helpful with this project but I’m at a point where I’m disappointed and need some serious help. Here’s my first etch followed by my fourth.
I’m using Laurel Mtn, Radio Shack acid 12oz/80oz water, boiling after rusting, carding to visible pattern, etching, rinsing and carding with baking soda. I thought about just stopping at the first etch because it looked good to me. I’ve covered the barrels smoothly with cotton pads alternating direction from muzzle to breach. I now have less contrast, and parts of the barrel look more like bluing with little pattern. Is it possible to remove the blue areas without damaging the pattern? If I have to start over I will. Your assistance is definitely needed and I’ll answer any questions the best I can. Thank you very much.Attachment 99230 |
All times are GMT -4. The time now is 12:45 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org