Repro screw pitch
Just got this plea from Charlie of Hill Rod and Gun in Bozeman. Anyone know that answer?
Hey Rich - Need your help - I am replacing the set screws on a Parker Repro 20 bore. The set screw is for the hinge pin/screw for the hammer. I have the replacement kit from Galazan but the screws are not appropriate so I am making them - what is the thread pitch? Cheers, Charlie |
The solution I always used when in this predicament if the old screw wasn't available, I would use some silicone dental impression material to make a plug of the inside thread and use an optical comparator to measure pitch and diameters.
|
I pulled a screw from my Repro 28 and put a thread gage to it. 44tps seemed the closest and a very good match.
|
All times are GMT -4. The time now is 04:19 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org