Rust removal
I'm sure this has been addressed before. Looking for helpful links. Thanks in advance.
|
Removing rust from where on your gun??
I have very successfully removed rust from all parts of guns, including the bores, using Big45 Frontier Pads and Hoppe's or other solvents. . |
Exterior barrel rust. Have heard of steaming, probably just need to send to a expert. Just purchased my first, and probably only Purdey. Will post pictures when I receive.
|
Frontier Pad and Kroil Oil. It has been discussed before on the forum. Look it up in the search engine.
|
I am no expert but I have good success with the Frontier pad that Dean and Matt alluded to. I also like the Kroil, it smells good as well.:)
|
I use a stainless steel scrubbie and any good quality gun oil. It'll remove the surface rust and not damage the bluing.
|
Old post RE: Frontier Pads.....
See pictures of my post #11 in this thread years ago. This Sauer was so rust covered you could not read any lettering on it or see case colors. WD-40 and a Frontier pad did the trick in a couple hours! I still have the gun and it still looks every bit as good as it did after cleaning it up back then.
http://parkerguns.org/forums/showthr...er+Pads&page=2 |
Like Mike I have bought some stainless steel scrubbie’s after using Frontier pads. They seem to work equally well.
I usually do a final clean up with Turtle wax chrome polish and rust remover. It works great for me. Doesn’t remove bluing but absolutely dissolves rust that is left behind after cleaning with a pad and oil. |
I have used very fine steel wool with Hoppiesand oil with success.
|
All times are GMT -4. The time now is 02:36 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org