New 8g Reloads
2 Attachment(s)
I have a cubic butt-load of Winchester industrial hulls that were disassembled by cutting off the crimp. So, these hulls are 3" instead of 3 1/2". No problem. I used the same new basic wad column but left out the 1/2" fiber wad from the shot cup. Then added an 8g OSC and made a roll crimp. This'll work.
|
Would the hull not successfully roll crimp without cutting some off? Where did you get your roll crimper?
|
Quote:
|
2 Attachment(s)
So here are some of the Winchester industrial "short" hulls with the Gualandi Hi-Cap wad. No other change in the wad column.
|
1 Attachment(s)
Better pic here, that last one was a wonky angle.
|
1 Attachment(s)
Bill, the roll crimper is a single pin die from BP.
|
Thanks.
|
You're welcome
|
Since on the 8 gauge subject,I thought I'd throw this in.Im working on converting a PW 375 to 8 gauge,and have a guy modifying a couple parts for me.Hope to have it up and running in a couple weeks.Anyway I was on the phone with Ponsness Warren this morning ordering a part and mentioned I'm doing this conversion and they told me they are working on an 8 gauge kit for the 375 loader.I guess they are swamped and didn't know when it would be available.Just thought I'd pass along this info.
BTW nice looking roll crimps. Jeff. |
If I were 40 years old, I would wait for the PW 8 gauge conversion. However, I'm 41 and will be long dead before they come up with it.
|
All times are GMT -4. The time now is 08:57 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org