I think the only way to accomplish that would be with a stop screw as others have suggested.

The travel of the ejectors otherwise is only limited by the stop plate...

How else could it be tuned? If you have a suggestion I'm sure a lot of folks here would like to know what you would suggest.






.

As long proper understanding of mechanism is done then a concept can be implemented and thinks will not go bad, that is why i guarantee all my work.

Mr. Janusz do you do case coloring of metal? Do you have any pictures of your work. I looked at the album you posted and if you recolored the barrels they look good.

Yes, I like those Twist barrels too. Did you do them?





.

Yes. This is my work. Yes i do case coloring traditional way,
Attachment 87108
Attachment 87109
Attachment 87110
Attachment 87111
Attachment 87112

Personally, I like the other fix.
A deeper dove tail.
I’d be concerned with the Ejector beating against the set screw with the second fix mentioned. May peen the hell out of the Ejector rod and the set screw.
That may cause internal issues in the future ?

Right Joe - to the point where you wouldn't be able to remove the screw if you needed to without major surgery.





.